Abstract
In this study, fluoridated hydroxyapatite coatings are prepared on Ti6Al4V alloy substrate through sol–gel method. The bonding strength is evaluated through two different methods: pull-out method and scanning scratch method. Both results show F incorporation could effectively increase the bonding between coating and substrate. It is found that the pull-out results are actually compounds of adhesion failure, cohesive failure and glue failure; while the critical loads in scanning scratch show only the coating-matrix adhesion strength. It is suggested that scanning scratch test is more suitable to evaluate the bonding strength of bioactive ceramic coatings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.