Abstract
This paper fabricated three-dimensional (3D) honeycomb sandwich structure fabrics with three different cross-section shapes on an ordinary loom by reasonable design with low cost. The 3D honeycomb sandwich structure composites were fabricated by the vacuum assisted resin transfer molding process. Then, the bending properties of 3D honeycomb sandwich structure composites with different cross-section shapes were tested. The results showed that the 3D honeycomb sandwich structure composite with a hexagonal cross-section shape had the maximum load, the 3D honeycomb sandwich structure composite with a triquetrous cross-section shape had the minimum load and the 3D honeycomb sandwich structure composite with a quadrangular cross-section shape had a load between the two. The bending failure mode showed that the 3D honeycomb sandwich structure composite had a typical bending failure mode with compression failure in the front and tensile failure in the back. Finally, the load–displacement curves and failure mode were obtained by FEM (Finite Element Method) simulation with ABAQUS software. The good agreements of comparisons proved the validity of the FEM.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
