Behavior in the electric current curve by changing the anodizing area

Abstract

In this work, we studied the change in the electric current and the length of the nanotubes depending on the area and the exposure time in the anodizing process. Over time the anodizing area was changed with a rate of 0.5 cm2 to 2.5 cm2 using a total anodizing time of 60 min, using a chemical solution (2ml /3 ml /0.30g ) and maintaining a constant anodizing voltage equal to 20 V. The behavior in the nanostructures was recorded by the evolution of the current density as a function of the anodizing time. The morphology of the nanostructures was analyzed by means of scanning electron microscopy (SEM). With the use of the Imagej program. The size, length and diameter of the titanium nanostructures are obtained. The sample that presented the best behavior was that of an anodizing area of ​​1.5 cm2 and an anodizing time of 36 min. This presents a surface where open nanotubes are observed in the upper part with a vertical length of 0.23 μm and a pattern thereof organized in a circular arrangement with a diameter of 0.035 μm. It was observed that increasing the area under these anodizing conditions decreased the length of the nanotubes. The mobility of the loads was always greater with the area of ​​exposure, which is observed in the increase of the current