Abstract
We proposed an autoparametric excitation harvester employing a microfabricated leaf spring for the base beam and a synchronized switch harvesting on inductor (SSHI) interface. Our harvester achieved miniaturization, low threshold acceleration of the autoparametric excitation, and increase in output power, compared with the previous work. The base beam for amplifying the excitation was microfabricated from a stainless steel film, through the photolithography followed by the wet-chemical etching. To trigger the autoparametric excitation, the main and the base beams are designed such that the resonance frequency for the base beam becomes twice higher than that for the main beam. The resonance frequencies obtained in experiment for the main and the base beams were 26.6 and 53.1 Hz, respectively. This study employed a self-powered parallel SSHI interface, which can increase the piezoelectric voltage and thus the output power, consuming only a small portion of the harvested energy. The harvester connected with the self-powered SSHI interface successfully displayed the autoparametric excitation at acceleration greater than 1.0 m/s2, and the output power showed 1.12 mW at the frequency of 53.1 Hz under the acceleration of 2.0 m/s2, which is 1.43-fold increase over the standard AC-DC interface.
Highlights
To increase output power for piezoelectric vibration energy harvesters (p-VEHs) significantly, the use of autoparametric excitation is one promising way [1, 2]
The base beam was microfabricated from the stainless steel film through the photolithography followed by the wet-chemical etching [3, 4]
Vp is rectified through the full bridge diodes, and the output DC voltage VDC is obtained across the resistive load connected with the smoothing capacitor Cs
Summary
To increase output power for piezoelectric vibration energy harvesters (p-VEHs) significantly, the use of autoparametric excitation is one promising way [1, 2]. To decrease the harvester's volume and lower the threshold acceleration, as well as to further increase the output power, we proposed a harvester employing a microfabricated leaf spring for the base beam and a nonlinear interface termed a synchronized switch harvesting on inductor (SSHI).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.