Assessment of the Qualification Test of the First Wall Qualification Mockup

Abstract

Understanding the manner in which the First Wall Qualification Mockup (FWQM) responds structurally to simulated ITER conditions is important to the establishment of a reliable first wall. This paper provides a thermal and structural response analysis for the first round of qualification tests performed at Sandia National Laboratories. The results display the stresses and strains created in the FWQM as a result of the thermal expansion that occurred when subjected to cyclic heat flux under simulated ITER normal and MARFE conditions. From this structural response, further insight may be gained into the likelihood of fatigue failure of the Beryllium//CuCrZr interface once the first wall is in operation in ITER. While fully determining the reliability of this joint is beyond the scope of this study, some suggestions are made as to how this topic might be addressed with further research. Also investigated are the thermal patterns seen during testing that indicated slight variation from the intended test parameters. It is shown that these disparities from the ideal test parameters do not significantly affect the qualification of the FWQM.