Approximate static balancing of a planar parallel cable-driven mechanism based on four-bar linkages and springs

Abstract

In parallel cable-driven mechanisms (PCDMs), the unilaterality of force transmission requires a minimum level of tension in the cables in order to preserve their geometry. As a result, the driving electrical motors need to produce continuous torques to keep the cables taut. We propose to use nonlinear springs to generate these minimum torques, while altering as little as possible the PCDM neutral equilibrium over its workspace. The design of the required nonlinear springs couples a four-bar linkage with commercially available springs. By our approach, the electrical motors only need to produce additional forces, i.e., those forces needed to generate accelerations and balance external forces applied to the end effector. This paper reports the method used to choose the optimum tension profile and the design of the ensuing nonlinear spring. An experimental verification is also performed, where the external forces that must be applied on the end effector to move it across the workspace are measured and compared with those predicted by the kinetostatic model.