Abstract

A numerical method is presented for evaluating the elastic-elastic contact of real rough surface contacts during running-in. For the surface contact, an elastic-plastic model based on the variational method is applied to analyze the pressure distribution and contact area of worn surfaces during running-in. In conjunction with the classical statistic model of Greenwood and Williamson, the numerical result showed that the plasticity index Ψ was decreased to one in the elastic range as running-in proceeded. In comparison with the Hertzian solution, the influence of the asperities is very significant on the pressure distribution, thereafter causing a higher peak value of contact pressure. For the subsurface, the interior stress from the von Mises criterion was calculated to evaluate the subsurface stress field subject to both normal and tangential forces. In the calculated of the interior stress, the total stress is decomposed into a fluctuating component and a smooth component. The fluctuating part is solved by using FFT from the concept of the convolution theorem while the smooth part is obtained directly by analytical solution. Calculations of contact area and subsurface stress on experimentally produced surfaces whose topography has been determined using an atomic force microscope and friction coefficient front sliding have been carried out. The results showed that asperities and friction coefficient gave rise to stress increase in the near-surface stress field and produced a high stress zone towards the surface. As a result, transverse asperity cracking was produced. The calculations and supporting experimental evidence clearly confirmed that the reduction of peak pressure during running-in decreased the plastic deformation of contact.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.