Abstract
The ITER CS is in an advanced state of design. Detailed analysis continues. In this paper, finite element analyses done by the US PT are presented. These analyses relate to a few issues still requiring some resolution. Finite element analyses by the ITER international team (IT) and other US PT analyses are cited for comparison with the finite element results. The degree of preload required to offset vertical tensions in the coils are discussed. Parametric analyses of different preloads and friction coefficients have been performed which point to a lower preload than that specified by the project. Lateral loading on the CS due to postulated off center electromagnetic loads are quantified. Lateral seismic loads are applied, and the existing and proposed restraint systems are discussed. Behavior of the upper flex supports is also available from the simulation model and will be compared with previous work. The coil leads are supported by the preload system tie-plates. Radial differential motion between the tie-plates and coils is quantified for the case where there is no radial coupling between the coils and tie-plates. Support provisions for the leads are discussed in the context of both load capacity and displacement absorbing ability
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
