Analysis of the Influence That Parameters Crookedness and Taper Have on Stack Volume by Using a 3D-Simulation Model of Wood Stacks

Abstract

The influence that parameters crookedness and taper have on the stack volume was analyzed by using a 3D-simulation model in this study. To do so, log length, diameters at the midpoint and both ends, crookedness, bark thickness, taper and ovality were measured in 1000 logs of Scots pine. From this database, several data sets with different proportions of crooked and tapered logs in stack as well as with different degrees of taper and crookedness were created and taken as basis to simulate the stacks and carry out the analysis. The results show how the variation of these parameters influences the stack volume and provide their volume variation grades. These rates of variation were compared with measurement guidelines of some countries and previous research works. In conclusion, the parameters crookedness and taper influence the stack volume to a considerable extent. Specifically, the stack volume is increased as the crookedness degree or the proportion of crooked logs increases. In contrast, the stack volume is reduced as the taper degree or the proportion of tapered logs increases. Furthermore, the results demonstrate the capability of this simulation model to provide accurate results which can serve as a basis for future studies.