Abstract

Food texture is one of the main features that affect the consumer's judgment. Instrumental texture analysis is suitable method for objective assessment of the texturometric characteristic of food. In this experimental work we have analysed textural properties of different traditional and commercial sausages originating from Slovakia. Twenty sausages were classified in four groups. Group 1 (traditional home-made sausages purchased directly from a producer), Group 2 (traditional sausages purchased from butchery), Group 3 (non-traditional sausages purchased from a supermarket) and Group 4 (non- traditional sausages purchased from a hypermarket). Once taken, samples were immediately transported to the laboratory. Samples were analysed immediately and after the storage 72 h at 25 °C and 80% relative humidity. Samples were analysed with texturometer TA-XT2 plus and we have used the Warner-Bratzler probe. The main reason of this experiment was to find differences for two selected textural parameters, firmness and toughness of the fresh and stored sausages. The average firmness and toughness of fresh sausages before storage were 1.83 kg and 12.86 kg.s-1 respectively. These values were increased after the storage. The average firmness and toughness of stored sausages were 2.74 kg and 19.23 kg.s-1 respectively. It means, storage affects the textural properties of sausages (p <0.05). We were observed decrease of the water activity after the storage. The loss of free water was 5.1% higher in the case of commercial sausages. Also, the protein content, fat content and minerals elements content were analysed. The content of overall protein was 5.8% higher in the traditional sausages. The fat content in commercial sausages was 3.36% higher in comparison to traditional sausages. The sensory quality of traditional sausages was better than commercial sausages.

Highlights

  • There are different kinds of meat products all over the world, among which fresh sausages represent an important part (Feiner, 2006)

  • In this experiment we were focused on the determination of firmness and toughness of different kind of sausages

  • The Principal Components Analysis (PCA) analysis of the products according to the firmness and toughness is presented in the Figure 1

Read more

Summary

Introduction

There are different kinds of meat products all over the world, among which fresh sausages represent an important part (Feiner, 2006). The Principal Components Analysis (PCA) was performed to reducing the original data and show position of products according to the textural parameters firmness and toughness. The Principal Components Analysis (PCA) was performed with the Hierarchical Clustering Procedure (HAC) to show differences between the results of paired samples of fresh and stored sausages in relation to firmness and toughness.

Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.