Analysis of RF Energy Harvesting in Uplink-NOMA IoT-Based Network

Abstract

Internet of Things (IoT) systems in general consist of a lot of devices with massive connectivity. Those devices are usually constrained with limited energy supply and can only operate at low power and low rate. One solution to limited energy is to use energy harvesting to provide sustainable energy. The set of technologies adopted in next-generation wireless communication systems, such as massive MIMO and Non-Orthogonal Multiple Access (NOMA), can provide solutions to increase the throughput of IoT systems. In this paper we investigate a cellular-based IoT system combined with energy harvesting and NOMA. We consider all base stations (BS) and IoT devices follow the Poisson Point Process (PPP) distribution in a given area. The unit time slot is divided into two phases, energy harvesting phase in downlink (DL) and data transmission phase in uplink (UL). That is, IoT devices will first harvest energy from all BS transmissions and then use the harvested energy to do the NOMA information transmission. We define an energy harvesting circle within which all IoT devices can harvest enough energy for NOMA transmission. The design objective is to maximize the total throughput in UL within the circle by varying the duration T of energy harvesting phase. In our work, we also consider the inter-cell interference in the throughput calculation. The analysis of Probability Mass Function (PMF) for IoT devices in the energy harvesting circle is also compared with simulation results. It is shown that the BS density needs to be carefully set so that the IoT devices in the energy harvesting circle receive relatively smaller interference and energy circles overlap only with small probability. Our simulations show that there exists an optimal T to achieve maximum throughput. When the BSs are densely deployed consequently the total throughput will decrease because of the interference.