Abstract
This paper proposes a new novel snubberless current-fed half-bridge front-end isolated dc/dc converter-based inverter for photovoltaic applications. It is suitable for grid-tied (utility interface) as well as off-grid (standalone) application based on the mode of control. The proposed converter attains clamping of the device voltage by secondary modulation, thus eliminating the need of snubber or active-clamp. Zero-current switching or natural commutation of primary devices and zero-voltage switching of secondary devices is achieved. Soft-switching is inherent owing to the proposed secondary modulation and is maintained during wide variation in voltage and power transfer capacity and thus is suitable for photovoltaic (PV) applications. Primary device voltage is clamped at reflected output voltage, and secondary device voltage is clamped at output voltage. Steady-state operation and analysis, and design procedure are presented. Simulation results using PSIM 9.0 are given to verify the proposed analysis and design. An experimental converter prototype rated at 200 W has been designed, built, and tested in the laboratory to verify and demonstrate the converter performance over wide variations in input voltage and output power for PV applications. The proposed converter is a true isolated boost converter and has higher voltage conversion (boost) ratio compared to the conventional active-clamped converter.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
