Abstract
AbstractIn the industrial production of aluminium by the electrolysis of alumina, electrolyte froth, which is a mixture of carbon and cryolite is obtained at a rate of 50 kg of froth per ton of aluminium produced. Cryolite can be recovered from this mixture by flotation. In this study, the effects of the following parameters on flotation were experimentally investigated: particle size, type, combination, dosage and ratio of reagents, and conditioning time. It is found that it is possible to decrease the carbon content of cryolite below 1% by suitably choosing the operating parameters. Electrolyte froth must be ground to —100 mesh size for the liberation of carbon particles captured in the cryolite matrix. Any combination of two of the reagents, kerosene, fuel oil, creosote and terebenthene yield good results if used together with pine oil. Pine oil is found to be a more effective frother compared to Pril, a commercial detergent. Satisfactory separations are obtained when a kerosene‐fuel oil mixture (50:50, v/v) is used as the collector with a dosage of 3.7 kg per ton of feed together with pine oil, the frother, with a dosage of 0.095 kg per ton of feed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Chemical Technology and Biotechnology. Chemical Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.