Abstract
A non-equilibrium wall-model based on unsteady 3D Reynolds-averaged Navier-Stokes (RANS) equations has been implemented in an unstructured mesh environment. The method is similar to that of the wall-model for structured mesh described by Wang and Moin [Phys. Fluids 14, 2043–2051 (2002)], but is supplemented by a new dynamic eddy viscosity/conductivity model that corrects the effect of the resolved Reynolds stress (resolved turbulent heat flux) on the skin friction (wall heat flux). This correction is crucial in predicting the correct level of the skin friction. Unlike earlier models, this eddy viscosity/conductivity model does not have a stress-matching procedure or a tunable free parameter, and it shows consistent performance over a wide range of Reynolds numbers. The wall-model is validated against canonical (attached) transitional and fully turbulent flows at moderate to very high Reynolds numbers: a turbulent channel flow at Reτ = 2000, an H-type transitional boundary layer up to Reθ = 3300, and a high Reynolds number boundary layer at Reθ = 31 000. Application to a separated flow over a NACA4412 airfoil operating close to maximum lift is also considered to test the performance of the wall-model in complex non-equilibrium flows.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
