An experimental study on the speciation of dissolved zinc, cadmium, lead and copper in river rhine and north sea water, by differential pulsed anodic stripping voltammetry

Abstract

Dissolved electroactive concentrations of zinc, cadmium, lead and copper in river Rhine and North Sea samples have been measured at natural and lower pH values by differential pulsed anodic stripping voltammetry using a Kemula-type hanging mercury drop electrode. Average concentrations detected in North Sea samples at salinities ⩾ 32‰ S and their range are (in μgl−1): 3.9 (2.0–7.5) for zinc, 0.23 (0.13–0.31) for cadmium, 0.3 (0.1–0.6) for lead and 0.3 (0.25–0.60) for copper (pH 8.1). The APDC-MIBK extracting/concentrating method, followed by AAS measurement applied to the same samples, resulted in 3.9 (2.0–7.5) for zinc, 0.11 (0.01–0.27) for cadmium, 0.5 (0.2–0.9) for lead and 1.6 (0.7–3.2) for copper. A fraction of the electroactive concentrations at pH 2.7 (6.1 for Zn) is electroactive at pH 8.1. The fractions are 100% for Cd, 20% for Cu, 13% for Pb and 40% for Zn. The remaining fractions are partly composed of organically bound species in solution. The low value for lead may be caused by the presence of particulate lead that is dissolved at low pH. Ionic copper and lead species, added separately to seawater at pH 8.1 are removed from the electroactive form, and taken up in (organic) complexes in the same ratio (at least for copper) as the species already present. Added ionic zinc is not removed within the time scale of the measurements (30 min). North Sea water at the natural pH has a complexing capacity, probably due to the presence of dissolved organic compounds, in a concentration equivalent to 3.10−7M copper. The complexing capacity is zero at pH 2.7. The usual method of standard addition for the determination of electroactive copper and lead concentrations may lead to erroneous results in samples where complexation of this type occurs.