An analysis and development of a dry-face mechanical shaft seal concept : G. Wilkes and P. F. Donlevy, Lubrication Eng., 26 (8) (1970) 273–280; 7 figs., 6 refs.

Abstract

Non-recessed journal bearings have been successfully used in various engineering applications because of their good performance over a wide range of speed and load, besides their relative simplicity in manufacturing. Due to many starts and stops in its lifespan, the bearing bush wears progressively on account of rubbing, which affects bearing performance. The present work is an attempt to analytically study the performance of a worn non-recessed (hole-entry) capillary-compensated hybrid journal-bearing system. FEM has been used to solve the Reynolds equation, governing the flow of lubricant in the bearing clearance space along with the restrictor flow equation using suitable iterative technique. A study is conducted for two configurations, i.e., symmetrical and asymmetrical hole-entry journal-bearing system. The simulated results of bearing characteristics parameters in terms of maximum fluid-film pressure, minimum fluid-film thickness, flow rate, frictional torque, rotor dynamic coefficients, stability threshold speed and whirl frequency ratio, etc. have been presented for the wide range of various values of load and speed. The results indicate that the wear affects the bearing performance considerably; therefore, a due consideration of wear defect should be given for an accurate prediction of the bearing performance over a number of cycles. The computed results further indicate that the influence of wear defect on journal bearing performance may be minimized if a designer selects a suitable bearing configuration.