Abstract
Longissimus width and depth were measured using ultrasound in steers (n = 174), bulls (n = 323), and heifers (n = 347) at yearling and prior to harvest. Yearling and preharvest muscle dimensions and carcass muscle area of bulls were largest (P<0.01). Steers had wider and deeper (P<0.01) longissimus than heifers at yearling; however, preharvest muscle width and depth and carcass muscle area were greater (P<0.01) for heifers. From yearling to harvest, muscle width of bulls and heifers increased at a similar rate, which was greater (P<0.01) than that of steers. Significant (P<0.01) differences existed for muscle depth increase from yearling to harvest, where bulls had the highest deposition rates, heifers had intermediate rates, and steers had the lowest deposition rates. Correlations of carcass muscle area with muscle depth were large and positive (0.52 to 0.81) and slightly larger than correlations with muscle width (0.51 to 0.74). Muscle depth was the best single predictor of carcass muscle area; however, two-trait prediction models including both muscle width and depth were superior to single-trait prediction models. At yearling (preharvest), predicted and carcass muscle areas differed by more than 9.68 cm2 for less than 2% (5%) of steers and heifers and less than 7% (4%) of bulls. Further, yearling and pre-harvest carcass muscle area predictions were within 4.84 cm2 of carcass measurements for approximately 54 to 65% of all animals, respectively. These results indicate that ultrasound muscle width and depth may be alternative predictors of carcass muscle area and may be useful in selection of potential replacements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.