Alteration of the growth rate and lag time ofLeuconostoc mesenteroides NRRL-B523

Abstract

Bacterial profile modification is an important enhanced oil recovery technique used to direct injected water into a reservoir's low permeability zone containing trapped crude oil. During water flooding, the use of bacteria to plug the high permeability water zone and divert flow into the oil-bearing low-permeability zone will have a significant economic impact. However, during the field implementation of bacterial profile modification, the rapid growth of bacteria near the injection well bore may hinder the subsequent injection of growth media so that profile modification of the reservoir occurs only in the immediate vicinity of the well bore. By slowing the growth rate and prolonging the lag phase, the onset of pore-space plugging may be delayed and the biologically active zone extended deep into the reservoir. High substrate loading, high pH values, and the addition of the growth inhibitors sodium dodecylsulfate and sodium benzoate have been used in combination to alter the growth characteristics of Leuconostoc mesenteroides NRRL-B523 grown in batch conditions. The highest sucrose concentration used in these studies, 500 g/L, produced lag times 12-fold greater than the slowest lag times achieved at low sucrose concentrations. When L. mesenteroides was grown in media containing 500 g/L sucrose, an alkaline pH value threshold was found above which bacteria did not grow. At this threshold pH value of 8.1, an average lag time of 200 h was observed. Increasing the concentration of sodium benzoate had no effect on lag time, but reduced the growth rate until the threshold concentration of 0.6%, above which bacteria did not grow. Last, it was found that a solution of 0.075 mM sodium dodecylsulfate in media containing 15 g/L sucrose completely inhibited bacterial growth.