Abstract

Dielectric elastomer materials are ideal candidates for developing high-agility micro air vehicles due to their electric field–induced deformation. Consequently, the aero-structural response and control authority of the dielectric elastomer material, VHB 4910, are characterized on an elliptical membrane wing. An experimental membrane wing platform was constructed by stretching VHB 4910 over a rigid elliptical wing-frame. The low Reynolds number (chord Reynolds number < 106) and aerodynamics of the elliptical wing were characterized when different electrostatic fields were applied to the membrane. We observe an overall increase in lift with maximum gains of 20% at an applied voltage of 4.5 kV and demonstrate the ability to delay stall. The time-averaged aerodynamic surface pressure is also investigated by comparing sting balance data and membrane deformation measured using visual image correlation. The experimental results are compared to a nonlinear finite element membrane model to further understand the effects of aerodynamic load and electric fields on membrane displacements. Model predictions of surface pressure provide insight into how the electrostrictive constitutive relations influence the fluid–structure interactions of the membrane. This is validated by comparing lift predictions from the model with time-averaged wind tunnel lift measurements near stall.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.