Advantages of carbon nanotubes in electrical discharge machining

Abstract

Carbon nanotubes (CNTs) have a small specific gravity and a straight-pin shape, which allow them to continuously float and to uniformly disperse throughout the entire dielectric-filled cavity with little agglomeration during electrical discharge machining (EDM). In the past, powder mixtures of silicon, aluminum, and chrome have been used in the EDM process. However, there are concerns about flushing the controlled gap between the electrode and the workpiece because of their heavy specific gravity and their associated non-uniform dispersion in the dielectric. In this study, the effect of adding CNT powders to the dielectric on the surface integrity and the machining efficiency of the workpiece were investigated. CNTs can avoid the agglomeration problem. The CNTs were fabricated by chemical vapor deposition and added to the dielectric at a concentration of 0.4 g/l. The average surface roughness of 0.09 μm was achieved within 1.2 h, and the material defects of the recast layer and the micro-cracks were considerably reduced. The adopted processing parameters were a negative electrode polarity, a discharge current of 1 A, a pulse duration of 2 μs, an open-circuit voltage of 280 V, and gap voltage of 70 V. This technology improved the surface finish by 70% and the machining time by 66%. The achievement is attributed to the nanoscale characteristics of the CNTs in the dielectrics. The surface force became large and was able to balance the gravity body force of the CNTs. Consequently, the electric arcs were well dispersed and more uniform across the electrode gap, thus significantly enhancing the performance of the electrical discharge. It is expected that carbon nanotubes will be used in many EDM applications.