Advanced Taxi Map Display Design for Low-Visibility Operations

Abstract

Conducting gate to gate operations during reduced visibility conditions is a major impediment to scheduled and unscheduled flight operations in the National Airspace System (NAS). Takeoff and landing minima are predicated on aircraft equipage and airport visibility (e.g., at some major airports, operations are terminated when visibility is below 700 ft runway visual range (RVR). Although some aircraft can land with zero-zero visibility, there are no ground or flight deck systems that allow them to taxi under low visibility conditions. A map display system designed to support low visibility taxi was evaluated by 12 B-747 flight crews in NASA's Crew Vehicle System Research Facility (CVSRF). Three taxi-map conditions were compared: paper map only, basic moving map, and advanced moving map. Crews landed and taxied along 24 different taxi routes under three visibility conditions: unlimited visibility, 700 ft RVR, and 300 ft RVR. Taxi time, errors and workload were collected for each taxi operation. Video tape recordings captured crew interactions and head-up and head-down times. Taxi times and errors were significantly better for crews with electronic maps than for crews with a paper map. Although crews with the advanced map experienced significantly more head-down time, the head down interval was significantly less than with the paper map and crew workload was significantly less. During the post-flight design review, pilots identified improvements in procedures and formatting that might enhance performance. They developed a procedure for safely switching from the NAV display to the map; and in general their comments were very favorable.