Acoustic driven circulation around cylindrical obstructions in microchannels

Abstract

We introduce an approach to generate direction-controlled circulation around cylindrical obstructions in channels using a piezoelectric transducer embedded porous-channel device fabricated by photolithography. To transmit acoustic signals into the channel, a single piezoelectric transducer was attached, operating at voltage levels of 5, 10, 15, and 20 V. Microscopic particle image velocimetry was employed to analyze the flow patterns in the channels. The analysis revealed two opposing circulation tendencies around the pillars located at two opposite sides of the channel in the longitudinal direction. The strength of circulation was found to be minimal in the middle of the channel and increased gradually toward the two ends of the channels. Furthermore, we observed that the circulation strength was maximum near the axial centerline and minimum at the boundaries along the width of the channels. Comparing the voltage levels, the higher voltage signals produced a higher strength of circulation than the lower voltage signals in all cases. Additionally, we found that the strength of circulation increased almost linearly and then decayed exponentially in the radial direction from the surfaces of the pillars. The observed velocity fields around individual cylinders matched well with the Görtler vortex model. The reported circulation phenomenon around pillars can be applied in non-contact fluid stirring and mixing in bio-chemical systems and lab-on-a-chip systems and may also provide additional degrees of freedom in object tweezing, trapping, and levitation.