Abstract
The pulsed wire method for magnetic field measurement has been developed by several groups. In most cases the thin wires were used and only the short magnets were measured to ignore the dispersion due to stiffness of the wires. In the application to the long insertion devices, a lot of spurious signals occurred and contaminated the normal field signals. In this article we demonstrate a new approach to applying the pulsed wire method to a long insertion undulator with a high field. Thick wire is used instead. Then we can cancel the dispersion and trace back the normal field signal by using the fast Fourier transform calculation. The results are quite comparable to Hall probe measurement.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.