Abstract
AbstractAccurately and efficiently modeling the drain-lag effects is crucial in nonlinear large-signal modeling for Gallium Nitride high electron mobility transistors. In this paper, a simplified yet accurate drain-lag model based on an industry standard large-signal model, i.e., the Chalmers (Angelov) model, extracted by means of pulsed S-parameter measurements, is presented. Instead of a complex nonlinear drain-lag description, only four constant parameters of the proposed drain-lag model need to be determined to accurately describe the large impacts of the drain-lag effects, e.g., drain-source current slump, typical kink observed in pulsed IV curves, and degradation of the output power. The extraction procedure of the parameters is based on pulsed S-parameter measurements, which allow to freeze traps and isolate the trapping effects from self-heating. It is also shown that the model can very accurately predict the load pull performance over a wide range of drain bias voltages. Finally, the large-signal network analyzer measurements at low frequency are used to further verify the proposed drain-lag model in the prediction of the output current in time domain under large-signal condition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Microwave and Wireless Technologies
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.