Abstract

The scanning electron microscope can be used to produce, in a way that is not possible with optical techniques or with casts of pore space, a quasi three-dimensional representation of the pore structure of sandstone, making it possible to determine the pore structure of sandstone, making it possible to determine the number of interconnected flow channels. Introduction Efforts have been made for many years to observe pore structure of sedimentary rocks on a microscopic pore structure of sedimentary rocks on a microscopic scale. A better description of the pore structure in reservoir rock would aid in the development of relations between flow through tube network models and flow in consolidated reservoir rock. The unique qualities of the scanning electron miscroscope (SEM) make it the ideal tool to use in a study of pore structure. Previous methods of studying pore structure included plastic casts of pore space and optical microscopy. There is now available a new method to observe three-dimensional flow channels in reservoir rock: a scanning electron microscope having variable magnification from 20 x to 20,000 x and approximately 1,000 times the depth of focus of the conventional light microscopes. This microscope also can obtain stereoscopic images, and can measure and diagram flow channels so that it is possible to construct a network of tubes that will model consolidated reservoir rock. Theory of the Scanning Electron Microscope The scanning electron microscope (SEM) functions by projecting a beam of electrons through magnetic focusing lenses at a specimen and recording secondary electrons excited by the primary beam. The amount of secondary electron emission portrays the topography of the specimen because more secondary electrons are emitted from high points than from low points. A schematic of the SEM is shown in Fig. 1. points. A schematic of the SEM is shown in Fig. 1. The property of the SEM that is of most importance in this study is its great depth of focus. The depth of focus results from using electrons rather than light. In the SEM, no electron trajectory is inclined more than 0.5 degrees from the optic axis, in contrast with the more than 60 degrees in optical microscopy (Fig. 2). The major problem encountered with the SEM is the build-up of a space charge on insulating specimens under bombardment by the 20 kev primary beam. To prevent charge build-up, insulating specimens must prevent charge build-up, insulating specimens must be coated with a conducting film to drain away the space charge. Sample Preparation The technique used to prepare rocks for examination with the SEM is the most critical part of obtaining micrographs. To obtain information about the pores of a rock, a surface must be prepared in such a way that the grains are cut through without being pulled from the rock matrix. This is difficult because the grains are stronger than the matrix. The problem was solved by application of techniques used to make thin-sections. Rock samples 5 cm in diameter x 5 cm thick were mounted in polyester resin, with care being taken not to allow the resin to enter the pores. JPT P. 543

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.