Abstract
Abstract Soils in southern Australia within the Mediterranean‐type climate zone vary widely in boron concentrations, from potentially deficient to toxic for plant growth. A general method is needed for the determination of boron in soils ranging from acidic to alkaline, with wide ranges of clay content and sodicity. The amounts of boron extracted were compared following boiling in 0.01M CaCl2 in test tubes in temperature‐controlled programmable digestion blocks, or in Erienmeyer flasks on hot plates under different analytical conditions. Comparisons were also made between CaCl2, hot water, and mannitol extractable boron. All analyses of boron were made by inductively coupled plasma spectrometry (ICPS). The extraction of boron was dependent on extraction time and temperature of the heating block. Addition of 20 ml of 0.01M CaCl2 to 10g of soil in 250 ml test tubes fitted with air condensers and placed in a pre‐heated temperature‐controlled digestion block set at 140°C and boiled for 30 minutes. This method...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
