Abstract
Electromagnetic Interference (EMI) test is an important part for the manufacture of power electronic equipment, which helps us not only analyze the noise characteristics of the Equipment Under Test (EUT) but also design EMI filters. The previous separation method for the Common Mode (CM) and Differential Mode (DM) noise was time consuming or costly. In this paper, a novel measurement system for CM and DM conducted EMI is described showing a good performance. The system consists of two parts, part 1: getting CM noise or DM noise through a current probe; part 2: obtaining another mode noise from a software-based method. A 150 w switch mode power supply is measured to verify the proposed measurement system. The noise spectra of CM and DM signal is shown, and the results obtained by software program are compared with those obtained from a current probe measurement showing a good concordance in terms of peak value.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
