Abstract
In this contribution, a non-conformal mapping is proposed to avoid mesh deformation or remeshing in 2D FEM simulation of electrical machines with rotor eccentricity. The mapping transforms the uniform part of the air gap with eccentric rotor back to its centric position. It is based on a combination of classical conformal mapping, centering the rotor but distorting its radius and an additional non-conformal mapping, which rescales the rotor properly. The approach is verified by simulating a surface mounted permanent magnet synchronous machine at open loop condition. Advantages and drawbacks of the proposed method are discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.