Abstract
Electrospray characteristics were studied using a pure room-temperature molten salt (i.e., an ionic liquid) at pressures around 10 −5 Pa as well as at atmospheric pressure. The ionic liquid N,N-diethyl-N-methyl-N-(2-methoxyethyl)ammonium bis(trifluoromethanesulfonyl)imide was tested, which has negligible vapor pressure and high conductivity. During electrospray, the ionic liquid was introduced at a constant flow rate into a stainless-steel capillary (i.d. 30 μm). It was demonstrated that stable electrosprayed currents exceeding ±1 μΑ were continuously produced in both positive and negative modes. The electrosprayed currents in a high vacuum were twice those at atmospheric pressure. It was found that gas pressure rose slightly with increasing electrosprayed currents. Residual gas analysis revealed that gas component at negative mode was different from that at positive mode. Experimental results indicate that vacuum electrospray of pure ionic liquids is applicable to a massive-cluster beam source for SIMS.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
