A molecular beacon design for a colorimetric loop-mediated isothermal amplification assay.

Abstract

In this study, a molecular beacon (MB) was designed for colorimetric loop-mediated isothermal amplification (cLAMP). The length of complementary bases on the MB, guanine and cytosine content (GC content), and hybridization sites of complementary bases were investigated as key factors affecting the design of the MB. We designed MBs consisting of 10, 15, and 20 complementary bases located at both ends of the HRPzyme. In the case of the long dumbbell DNA structure amplified from the hlyA gene of Listeria monocytogenes, possessing a flat region (F1c-B1) of 61base pairs (bp), an MB was designed to intercalate into the flat region between the F1c and B1 regions of the LAMP amplicons. In the case of the short dumbbell DNA structure amplified from the bcfD gene of Salmonella species possessing a flat region (F1c-B1) length of 6bp, another MB was designed to intercalate into the LoopF or LoopB regions of the LAMP amplicons. The results revealed that the hybridization site of the MB on the LAMP amplicons was not crucial in designing the MB, but the GC content was an important factor. The highest hybridization efficiencies for LAMP amplicons were obtained from hlyA gene-specific and bcfD gene-specific MBs containing 20- and 15-base complementary sequences, respectively, which exhibited the highest GC content. Therefore, designing MBs with a high GC content is an effective solution to overcome the low hybridization efficiency of cLAMP assays. The results obtained can be used as primary data for designing MBs to improve cLAMP accessibility.