A Method for the Reduction of Out-of-Band Measurement Errors in Multi-band Instruments using Synthetic Source Distributions

Abstract

A method to reduce multi-band sensor measurement biases due to finite out-of-band response is described. The method takes advantage of the fact that out-of-band measurement errors cancel if the calibration source and the measured source have the same spectral distributions—independent of their spectral distributions or the magnitude of a sensor band’s out-of-band response. Using a known spectral responsivity, a synthetic, arbitrary source spectral distribution can replace a realized spectral distribution in the measurement equation and the signal can be calculated rather than measured. Given the freedom to select any arbitrary distribution for the synthetic source, the efficacy of the approach depends on the fidelity of the replication of the measured spectrum by the synthetic source spectrum. To illustrate the method, an example application is given of top-of-the-atmosphere measurements of water-leaving radiance by multi-band filter radiometers on celestial Earth-viewing sensors.