Abstract
We present an optical walk-off sensor with an angular sensitivity of a few nrad/Hz above 1 mHz and 0.4 nrad/Hz above 100 mHz. This experiment furthers previous research into the walk-off sensor capabilities through an improved input laser, reduction in air optical travel length, and position control on photo-diodes. The angle change measured in this walk-off scheme features a knife edge to split the beam into two separate fiber coupled photo-diodes to minimize power dissipation in the thermally sensitive region. Using this photo-diode power differential as an error signal, a simple control scheme is used to maintain the balance position, increasing common mode rejection and improving dynamic range by mitigating thermal drift. The in-vacuum component of the optical readout takes up a volume less than 100 mm × 100 mm × 50 mm. This experiment shows that the walk-off sensor provides a simple and compact readout scheme with nanoradian sensitivity for angle sensing at low frequencies.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
