A high sensitive MEMS capacitive fingerprint sensor using slotted membrane

Abstract

In this paper a novel single-chip microelectromechanical systems (MEMS) capacitive fingerprint sensor with slotted membrane is developed to improve the sensitivity. The capacitive sensor consists of a thin, flexible membrane and a rigid back plate with air gap. In this study with making slots in upper electrode to decrease the mechanical stiffness of the membrane, using proportional T-shaped protrusion on diaphragm in order to concentrate the force from finger ridges, making holes in lower electrode to reduce the air damping and using low stress material for diaphragm, we have been succeeded to design a novel MEMS fingerprint sensor with high sensitivity compared with the previous works (Sato et al., IEEE Trans Electron Devices 52:1026–1032, 2005; Damghanian and Majlis, 2008 IEEE International Conference on Semiconductor Electronics (ICSE 2008), pp 634–638 2008). The behaviors of the fingerprint sensor with clamped and slotted membranes are analyzed using the finite element method (FEM). The results yield a sensitivity of 1.44 fF/Mpa for the clamped and 3.22 fF/Mpa for the slotted fingerprint sensor with a 50 × 50 μm2 diaphragm. The sensitivity of the slotted structure is increased 2.236 times.