Abstract
Abstract We report on a gas-sensor-based measurement setup for the detection of volatile degradation products directly in the extrusion process. In contrast to available measurement tools, the system is located in the air flow and works independently of the polymer melt flow. Therefore, the sensor can be used also for non-transparent melts with different colors and filler contents. For process validation, the measurement setup was tested offline using selected organic solvents, as well as directly in the extrusion process using talc-filled polypropylene compounds. We show that the amount of lubricants, the shear load, as well as the temperature and the back pressure influence the level of low molecular weight volatile compounds (LMWVOC) and finally the gas-sensor value.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
