Abstract

This paper introduces a rational approach for the design of continuity plates and associated welds in steel special moment frame (SMF) connections. The current AISC Seismic Provisions require welds attaching continuity plates to develop the full strength of the plate, resulting in the need to use complete-joint-penetration (CJP) groove welds. The combination of continuity plate thickness requirements, welding process and weld inspection often leads to costly detailing that may be overly conservative. The proposed design procedure, which is based on the relative flexibility between the column flange and continuity plate, aims to quantify the seismic force demand on continuity plates, thus allowing designers to efficiently size both the continuity plate thickness and the associated welded joints. In addition, the design procedure may allow the use of fillet welds or partial-joint-penetration groove welds as opposed to CJP welds, leading to a more economical design and fabrication. Formulation of the design procedure through analytical studies, including finite element analysis, is outlined.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.