Abstract
Influence of SEN design and its depth below the meniscus on liquid steel flow inside a large width thin slab mold was studied using a 1:1 scale water model. Fluid flow characterization was performed through Digital Particle Image Velocimetry techniques, measurements of bath oscillations and tracer dispersion experiments. Two designs of SEN with four ports (two lateral ports with two bottom ports) were investigated. SEN-1 has a wider bottom base and SEN-2 has a narrow one. Both SEN's provide fluid flows in the mold with upper and lower recirculating flows. Jets emerging from the lateral and bottom ports do not overlap although the surface area of the lateral jet of SEN-1 works inefficiently as compared with that of SEN-2. SEN-1 promotes higher bath oscillations than SEN-2 because the lateral jets travel almost horizontally toward the narrow face. This enhances fluid velocities along the narrow wall until the bath surface. A recirculating flow is formed close to the SEN-1 in the upper bath surface that provokes also high bath oscillations. Design of SEN-2 avoids these flow defects yielding more stable fluid flows. Rising the SEN depths alters negatively the flow characteristics, although SEN-2 is better than SEN-1. Generally speaking both designs yield complex turbulent and unsteady flows and a better SEN design is suggested.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
