Abstract
Light resin transfer moulding (LRTM) has been developed as an alternative to vacuum infusion (VI) but a direct comparison between the two processes is needed to quantify any advantages. This paper uses a technical cost model and an empirical study to show the potential financial and performance benefits of LRTM for manufacture of a generic 40 m wind turbine blade shell. The use of LRTM when compared to VI demonstrated a possible 3% cost saving, improved dimensional stability (5.5%), and reductions in resin wastage (3%) and infusion time (25%). A decrease in internal void formation (0.9%) resulted in an increase in mechanical performance (<4%) for LRTM moulded parts.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
