Abstract
Comparisons are reported for composite samples of similar resin and fibre systems which were processed using the wet lay-up with autoclave consolidation and resin transfer moulding (RTM) by vacuum impregnation. Similar degrees of cure were obtained for laminates using the two methods of processing and the arising thermal and physical properties (tensile, flexural, interlaminar shear strength (ILSS), void content and thickness variation) were measured. The fibre dominated properties (i.e. flexural and tensile strength) were found to be higher for the autoclaved samples due to the higher volume fraction arising from the superior compaction pressure, although when normalised on the basis of fibre volume fraction the results were similar. The matrix dominated ILSS values were higher for the RTM samples and this was attributed to improved wetting, reduced void content and a slightly lower degree of cure. Thermal analysis also indicated that the autoclaved (60% glass fibre by volume) composite attained a slightly higher glass transition temperature than that achieved by RTM (50% fibre by volume) for similar cure times and cure temperatures. The significance of the results in an industrial context is discussed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Composites Part A: Applied Science and Manufacturing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
