Abstract
The preconcentration efficiency expressed as an enrichment factor (EF) in knotted and serpentine reactors (SR) for FI sorption and preconcentration for the off-line determination of Cd(II), Ni(II), Co(II),Cu(II), Pb(II), Zn(II), Mo(VI), Cr(VI) and W(VI) with ICP-MS was investigated. The preconcentration was carried out by the formation of metal–pyrrolidine dithiocarbamate complex in an acidic solution and sorbed onto the inner wall of the PTFE reactors. The EFs were determined as the ratio between the analyte intensities after preconcentration using the reactors and that obtained without using the reactors. Comparing the two procedures for the equal reactor length (150 cm), the higher EFs obtained by using knotted reactor (KR) were observed for all elements. With the preconcentration time of 120 s and a sample flow rate of 1.2 ml min −1, the EFs of 4–36 and 3–12 were gained using knotted and SRs, respectively. The results obtained indicate that the KR is preferable to use for flow injection sorption preconcentration system over the SR.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.