Abstract
Results of an extensive experimental investigation performed to study the effect of different values of wall heat flux in a rectangular PCM (phase change material) test cell on the melting process are presented. A new experimental system consisting of a rectangular cross-section test cell formed from polycarbonate sheet, copper plates and mica heaters was constructed. During experiments uniform wall heat flux (q″wall = 675, 960 and 1295 W/m2) were applied to both the left and right sides of the test cell. Thermocouples were used to measure the temperature at different locations inside the PCM and on the surface of the copper plates and an infrared camera was used to measure the polycarbonate sheet external surface temperature distribution. The results show the expected strong correlation between the magnitude of wall heat flux and the melt fraction in the PCM as it drives the convective heat transfer. The transparent polycarbonate wall makes it possible to observe the location of the solid/liquid interface and determine melt fractions. The experiments have produced a significant experimental data set for the validation of numerical models simulating the solid/liquid phase change process and PCM melting in geometrical configurations relevant to, for example, latent heat thermal energy storage systems.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
