A Closed-Form Design Technique for Ultra-Wideband Doherty Power Amplifiers

Abstract

This paper presents an innovative architecture to drastically enlarge the bandwidth of the Doherty power amplifier (DPA). The proposed topology, based on novel input/output splitting/combining networks, allows to overcome the typical bandwidth limiting factors of the conventional DPA. A complete and rigorous theoretical investigation of the developed architecture is presented leading to a closed-form formulation suitable for a direct synthesis of ultra-wideband DPAs. The theoretical formulation is validated through the design, realization, and test of a hybrid prototype based on commercial GaN HEMT device showing a fractional bandwidth larger than 83%. From 1.05 to 2.55 GHz, experimental results with continuous-wave signals have shown efficiency levels within 83%-45% and within 58%-35% at about 42- and 36-dBm output power, respectively. The DPA has also been tested and digitally predistorted by using a 5-MHz Third Generation Partnership Project (3GPP) signal. In particular, to evaluate the ultra-wideband and the multi-mode capabilities of the prototype, f <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">1</sub> = 1.2 GHz, f <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> = 1.8 GHz, and f <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> = 2.5 GHz have been selected as carrier frequencies for the 3GPP signal. Under these conditions and at 36-dBm average output power, the DPA shows 52%, 35%, and 52% efficiency and an adjacent channel power ratio always lower than -43 dBc.