Abstract
BESMs (building energy simulation models) play an important role in the design, optimization and retrofit of buildings. Developing a BESM is relatively simple in the building design phase because nearly all inputs are known from design parameters. However, in the building operation phase, developing and calibrating a BESM becomes difficult because all operating parameters must be adjusted according to real-time data. All of these parameters are difficult to measure, and they vary over time. Existing calibration methods of BESMs, which involve hundreds of input parameters, lack standard procedures and require specialized engineers. Engineers must randomly adjust input parameters until the output energy use matches measured energy use. To solve the problem above, a new calibration approach with a detailed procedure is proposed in this paper. This approach relies on electricity submetering data and HVAC (Heating, Ventilation and Air Conditioning) cooling/heating loads. These data are becoming more available in commercial buildings. A case study is demonstrated in a large commercial building with satisfying results. The CV (coefficient of variation) and MBE (mean bias error) of the total hourly electricity consumption simulation, excluding HVAC, are 4% and 3%, respectively. The CVs of an HVAC system are 12% (chiller), 6% (pump) and 5% (fan), and the MBEs are 10% (chiller), 5% (pump) and 4% (fan).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.