Abstract
Direct conversion receivers are widely used for full duplex mobile radio communication systems. This paper describes a novel SAW-less single-ended RF amplifier connected to a single-ended mixer with a feedback loop that suppresses the second-order distortion from TX cross modulation of the LO-leakage as well as DC-offset at the mixer output. In Monte Carlo simulations the design achieves +47 dBm minimum IIP2 with 32 dB conversion voltage gain. The advantage with the proposed architecture is that it is fully single-ended. Especially in multiband integrated radios this is highly desirable since the pin-count for the LNAs is reduced by half. The PCB routing of the RF input signal is simplified. The design requires two off-chip filter capacitors of non critical value intended to be placed on the laminate inside the package.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
