Abstract
A 900-MHz SAW (surface acoustic wave) resonator filter for the front end has been fabricated on a 45 degrees rotated X cut Z propagation Li/sub 2/B/sub 4/O/sub 7/ crystal. The SAW resonator filter consists of three IDTs (interdigital transducers) and two reflectors with Al electrodes. When the Al thickness is below 500 AA, the insertion loss increases steeply. On the other hand, when the Al thickness is over 800 AA, the insertion loss rises in the filter. Therefore, the Al thickness is determined at 740 AA to improve the insertion loss on the basis of experimental results. The filter has a center frequency of 914 MHz, an insertion loss of 3 dB, and a rejection level of more than 60 dB. The aperture is determined to reduce transversal modes. The center frequency varies 350 ppm and the passband ripple is less than 1.5 dB in the temperature range from -10 degrees C to +55 degrees C. The filter has sufficient electrical characteristics for a front-end filter. >
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
