A 3-Dimensional-Printed Spine Localizer: Introducing the Concept of Online Dissemination of Novel Surgical Instruments.

Abstract

Background/AimsTo date, applications of 3-dimensional (3D) printing in neurosurgery have been limited to the creation of anatomical models for training and simulation, fabrication of customized implants, and production of patient-specific surgical tool guides. We aim to demonstrate a new application of this technology for the online dissemination of novel surgical instrument designs across the world. MethodsA link to a 3D printing file and instructions for assembly of a spine localizer are included in this article. This device was used to determine the optimal location of skin incision in lumbar microsurgery in 43 consecutive patients. Data regarding the accuracy of the surgeon's initial estimate of the target site based on palpation of anatomical landmarks and the accuracy of the localizer device in locating the target spine segment were prospectively collected. ResultsIn 35 cases (81%), the surgeon’s initial estimate of the target site was correct. In the remaining 8 cases (19%), the initial estimate was off by 1 motion segment. Inaccuracy of the surgeon’s estimate was found to be associated with a higher body mass index and the presence of transitional lumbosacral anatomy, but not with age, sex, or location of the target segment. In all patients, the location of the incision guided by the localizer was found to overlie the target segment, yielding a device accuracy of 100%. There was no need to extend the incision or modify the surgical trajectory. ConclusionThis 3D-printable localizer serves as an example of a device that can be disseminated online and printed at the point of use, thus promoting online tool-sharing by neurosurgeons.