Abstract
AbstractFour‐dimensional (4D) printing, which combines a three‐dimensional (3D) printing process with dynamic modulation of materials, provides a possible solution to achieve stimuli‐responsive microstructure that exhibit more complex functionality. One of the potential applications for these stimuli‐responsive hydrogels is switchable passive radiative cooling and warming. However, most current attempts are limited to mono‐functionality, either radiative cooling or warming only. In this article, we demonstrate a double‐side morphing flower structure for a dual functionality, switchable cooling or warming dependent on the environment. The morphing structure was designed with the aid of emissivity calculations and then fabricated by the 3D printing method. The transition between open‐flower and close‐flower states occurs at 32°C within a minute, resulting in ~35% emissivity difference between these two states. As a result, the power difference between inner layer and outer layer was as high as 22 W/m2 which is a function of pyramid bottom size.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
