3D finite element modeling of sand particle fracture based on in situ X‐Ray synchrotron imaging

Abstract

SummaryCompressive loading of granular materials causes inter‐particle forces to develop and evolve into force chains that propagate through the granular body. At high‐applied compressive stresses, inter‐particle forces will be large enough to cause particle fracture, affecting the constitutive behavior of granular materials. The first step to modeling particle fracture within force chains in granular mass is to understand and model the fracture of a single particle using actual three‐dimensional (3D) particle shape. In this paper, the fracture mode of individual silica sand particles was captured using 3D x‐ray radiography and Synchrotron Micro‐computed Tomography (SMT) during in situ compression experiments. The SMT images were used to reconstruct particle surfaces through image processing techniques. Particle surface was then imported into Abaqus finite element (FE) software where the experimental loading setup was modeled using the extended finite element method (XFEM) where particle fracture was compared to experimental fracture mode viewed in radiograph images that were acquired during experimental loading. Load‐displacement relationships of the FE analysis were also compared with experimental measurements. 3D FE modeling of particle fracture offers an excellent tool to map stress distribution and monitors crack initiation and propagation within individual sand particles. Copyright © 2015 John Wiley & Sons, Ltd.