РОЗРОБКА АНТИСТАТИЧНИХ І НАПІВПРОВІДНИКОВИХ КОМПОЗИЦІЙ ПОЛІЕТИЛЕН/ПОЛІАНІЛІН ТА ПОЛІВІНІЛХЛОРИД/ПОЛІАНІЛІН

Abstract

The effect of the polyaniline content on the mechanical, rheological and electrical properties of polyethylene and polyvinylchloride compositions for the production of antistatic and semiconductive materials was established. Samples of polymer composites were obtained in two stages: 1) mixing of components in a mixer type "disk in disk"; 2) pressing into films by the method of "hot pressing." Tensile strength, relative elongation, melt flow index and specific volume electrical resistance of the compositions were investigated by standard methods. It was found that an increase in the volume content of polyaniline in the polyethylene and polyvinylchloride matrix leads to a monotonic decrease in the melt flow index, as well as tensile strength and relative elongation. At the same time, there is a significant decrease in the specific volume electrical resistance in polyethylene and polyvinylchloride composite films, which contain up to 30% vol. of polyaniline. The reduction of the tensile strength and the relative elongation of films from compositions containing up to 30% vol. of polyaniline. This is due to the decrease in the viscosity of the melt-filled compositions, as evidenced by the decrease in the flow index of the melt polyethylene compositions from 3 to 2 g / 10 min, and polyvinylchloride – from 13 to 3 g / 10 min. Specific volume electrical resistance naturally decreases with increasing volume concentration of the filler in ranges from 1014 to 102 Ohm ∙ m for polyethylene compositions and from 1010 to 101 Ohm ∙ m for polyvinylchloride compositions. The developed polyethylene and polyvinylchloride compositions filled with polyaniline can be used for the production of polymer products with antistatic and semiconductive properties.