Abstract
An Electro Discharge Compaction (EDC) process was used to sinter iron powders mechanically ground (MG) by low energy ball milling. The sintered specimen preserved the grain size of MG powders. In the case of MG powders ground for 10hours, the grain size of the sintered specimen was about 50nm. This specimen exhibited, in the bend test, an yield strength about 1.4times larger than that of sintered non-ground powder.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of the Japan Society of Powder and Powder Metallurgy
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.