Abstract

The work develops the models of two principal diffusional transformations in high-chromium iron alloys on continuous cooling, viz. precipitation of secondary carbides (Cr, Fe)7C3 from aus-tenite and pearlitic decomposition of the latter. Literature experimental data for alloys of various composi-tion were used for analysis. Chemical composition of austenite by the end of austenitizing holding was de-termined using previously developed models, and then the exact expression describing isothermal precipita-tion of carbides from supercooled austenite was found based on the general equation following from the ki-netic theory of phase transformations. It was found out that the time exponent n in that expression equals to 3/2, which corresponds to the case of preferred precipitation of very fine carbide particles. For transition to the continuous cooling condition the C-curve of isothermal carbide precipitation was approximated by a square parabola. This permitted to find the relation between cooling rate and the amount of precipitated car-bide phase by means of the Scheil–Steinberg integral. Further comparison with the experimentally observed increase of martensitic point allowed to determine the numerical parameters of the model and their depend-ence on carbide composition of a given alloy. For the pearlitic transformation, a previously developed mod-el describing the parameters of temperature dependence of the Avrami equation coefficients on austenite composition was employed. That model was generalized for the continuous cooling case in the same was as above. As a result, CCT diagrams of diffusional austenite transformations in high-chromium alloys were calculated, that in general corresponded well the experimental ones.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.